Yamaha MTN1000 2016 Service Manual page 524

Fault code No.
Item
1 Connection of accelerator posi-
tion sensor coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Wire harness continuity.
P2122, P2123, P2127, P2128, P2138
[P2122] Accelerator position sensor: open or ground short circuit
detected.
[P2123] Accelerator position sensor: power short circuit detected.
[P2127] Accelerator position sensor: ground short circuit detected.
[P2128] Accelerator position sensor: open or power short circuit
detected.
[P2138] Accelerator position sensor: output voltage deviation error.
Improperly connected  Con-
nect the coupler securely or
replace the wire harness.
Improperly connected  Con-
nect the coupler securely or
replace the wire harness.
Open or short circuit  Replace
the wire harness.
8-107
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered"  Go
to item 7 and finish the service.
Condition is "Detected"  Go to
item 2.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered"  Go
to item 7 and finish the service.
Condition is "Detected"  Go to
item 3.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered"  Go
to item 7 and finish the service.
Condition is "Detected"  Go to
item 4.