Yamaha MTN1000 2016 Service Manual page 624

EWA14110
WARNING
• Handle the intake air temperature sensor
with special care.
• Never subject the intake air temperature
sensor to strong shocks. If the intake air
temperature sensor is dropped, replace it.
2. Check:
• Intake air temperature sensor resistance
Out of specification  Replace.
Intake air temperature sensor re-
sistance
5400.0–6600.0  at 0 C (5400.0–
6600.0  at 32 F)
Intake air temperature sensor re-
sistance
290–389  at 80 C (290–389  at
176 F)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester (  1 k/  100)
to the intake air temperature sensor terminal
as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
b. Immerse the intake air temperature sensor
"1" in a container filled with water "2".
TIP
Make sure that the intake air temperature sensor
terminals do not get wet.
c. Place a thermometer "3" in the water.
d. Slowly heat the water, then let it cool down to
the specified temperature.
e. Measure the intake air temperature sensor
resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
• Intake air temperature sensor
ELECTRICAL COMPONENTS
EAS30598
CHECKING THE STEERING DAMPER
SOLENOID
1. Remove:
• Air scoop (right)
Refer to "GENERAL CHASSIS (1)" on page
4-1.
2. Check:
• Steering damper solenoid resistance
Out of specification  Replace the steering
damper assembly.
Steering damper solenoid resis-
tance
49.82–56.18 
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the steering damper lead coupler
from wire harness.
b. Connect the pocket tester (  10) to the
steering damper lead coupler.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
black "1"
• Negative tester probe
black "2"
c. Measure the steering damper solenoid resis-
tance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30681
CHECKING THE FUEL INJECTORS
The following procedure applies to all of the fuel
injectors.
1. Remove:
• Fuel injector
Refer to "THROTTLE BODIES" on page 7-5.
2. Check:
• Fuel injector resistance
8-207
B B
1 2