1. ECU (Engine Control Unit)
2. Throttle position sensor
3. ECU lead
4. Fuel tank drain hose
5. Rectifier/regulator lead
6. Gear position sensor lead
7. Clamp
8. Sidestand switch lead
9. O
sensor lead
2
10.Oil pressure switch lead
11.Thermostat assembly
12.Plastic locking tie
13.Stator coil assembly lead
A. To fuel tank
B. The ECU lead may protrude out from the
ECU cover.
C. Route the fuel tank drain hose to the inside of
the frame and wire harness.
D. Place the oil pressure switch connector, side-
stand switch coupler, shift switch coupler (for
optional components), O
and crankshaft position sensor coupler inside
the coupler cover. The couplers may be posi-
tioned in any order.
E. Fasten the fuel tank drain hose, oil pressure
switch lead, sidestand switch lead, and O
sensor lead with the clamp. Install the clamp
to the holder. Face the opening of the clamp
forward.
F. The fuel tank drain hose should extend out of
the clamp by 50 mm (1.97 in) or more.
G. Fasten the straight portion of the thermostat
assembly and stator coil assembly lead with
the plastic locking tie. Point the end of the
plastic locking tie rearward and diagonally
downward. Do not cut off the excess end of
the plastic locking tie.
sensor coupler,
2
2
2-50
CABLE ROUTING