Yamaha MTN1000 2016 Service Manual page 21

1
2
1. Front wheel sensor
2. Rear wheel sensor
3. ABS ECU
4. Traction control system switch
5. ECU
A. Signal conversion
B. Slip amount calculation
Traction control system
The traction control system (TCS) helps maintain traction when accelerating on slippery surfaces, such
as unpaved or wet roads. If sensors detect that the rear wheel is starting to slip (uncontrolled spinning),
the traction control system assists by regulating engine power as needed until traction is restored.
EWA15432
WARNING
The traction control system is not a substitute for riding appropriately for the conditions. Trac-
tion control cannot prevent loss of traction due to excessive speed when entering turns, when
accelerating hard at a sharp lean angle, or while braking, and cannot prevent front wheel slip-
ping. As with any motorcycle, approach surfaces that may be slippery with caution and avoid
especially slippery surfaces.
The " " indicator light flashes when traction control has engaged. You may notice slight changes in
engine and exhaust sounds when the system has engaged.
In certain conditions, the traction control system may be automatically disabled. Should this happen,
the " " indicator light and the "
The TCS display indicates the current TCS setting. There are four settings.
TCS "OFF"
TCS "OFF" turns the traction control system off.
TCS "1"
TCS "1" minimizes traction control system assist. Select this mode for sporty riding.
3
A
B
A
4
" warning light will come on.
1-12
5
C
D
C. Exceeds preset value
D. Actuator control
E. Fuel cut-off
F. Ignition timing (retarded)
G. Traction control system indicator light
(flashes)
H. YCC-T motor throttle valve opening
(decreased)
FEATURES
E
F
G
H