Yamaha MTN1000 2016 Service Manual page 554

Fault code No.
Item
B-5 Check the fuse. (main fuse,
ignition fuse, cruise control
fuse)
B-6 Wire harness continuity.
B-7 Defective cruise control setting
switch.
B-8 Malfunction in ECU.
B-9 Delete the fault code and check
that the engine trouble warning
light goes off.
P0564
A Cruise control setting switch "RES+": open or short circuit is
detected.
Cruise control setting switch "SET–": open or short circuit is
B
detected.
Abnormality  Replace the
fuse. (main fuse, ignition fuse,
cruise control fuse)
Open or short circuit  Replace
the wire harness.
Between battery and main
switch coupler.
red–red
Between main switch coupler
and left handlebar switch cou-
pler.
red/white–yellow/white
Between left handlebar switch
coupler and ECU coupler.
green/blue–green/blue
Replace the left handlebar
switch.
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-194.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
8-137
CRUISE CONTROL SYSTEM
Turn the main switch to "ON".
Push and release the "SET–"
side of the cruise control setting
switch, and then check the con-
dition of the fault code using the
malfunction mode of the
Yamaha diagnostic tool.
Condition is "Recovered"  Go
to item B-9 and finish the ser-
vice.
Condition is "Detected"  Go to
item B-6.
Turn the main switch to "ON".
Push and release the "SET–"
side of the cruise control setting
switch, and then check the con-
dition of the fault code using the
malfunction mode of the
Yamaha diagnostic tool.
Condition is "Recovered"  Go
to item B-9 and finish the ser-
vice.
Condition is "Detected"  Go to
item B-7.
Turn the main switch to "ON".
Push the "RES+" side and
"SET–" side of the cruise con-
trol setting switch, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item B-9 and finish the ser-
vice.
Condition is "Detected"  Go to
item B-8.