Yamaha MTN1000 2016 Service Manual page 442

The neutral indicator light fails to come on.
1. Check the neutral switch.
Refer to "CHECKING THE
SWITCHES" on page 8-191.
OK
2. Check the relay unit (diode).
Refer to "CHECKING THE RELAY
UNIT (DIODE)" on page 8-199.
OK
3. Check the entire signaling system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-21.
OK
Replace the meter assembly.
The oil pressure warning light fails to come on when the main switch is set to "ON".
1. Check the entire signaling system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-21.
OK
2. Disconnect the oil pressure switch
lead from the oil pressure switch,
and then check whether the oil pres-
sure warning light comes on when
the lead is connected to the engine
ground.
OK
Replace the oil pressure switch.
The oil pressure warning light remains on after the engine is started.
1. Check the entire signaling system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-21.
OK
2. Measure the engine oil pressure.
Refer to "MEASURING THE
ENGINE OIL PRESSURE" on page
3-27.
OK
Replace the oil pressure switch.
Replace the neutral switch.
NG
Replace the relay unit.
NG
Properly connect or repair the signaling
system's wiring.
NG
Properly connect or replace the wiring har-
ness.
NG
Replace the meter assembly.
NG
Properly connect or replace the wiring har-
ness.
NG
Check the engine oil leakage, oil viscosity,
oil seal, oil filter, or oil pump.
NG
8-25
SIGNALING SYSTEM