Yamaha MTN1000 2016 Service Manual page 279

1
5. Install:
• Shift rod joint "1"
• Shift rod "2"
TIP
• Install the shift rod joint and shift rod shown in
the illustration.
• Be sure to install the shift rod joints so that they
are parallel.
• Make sure that any twisting of the shift rod
joints is within ±5.
• Install the shift rod so that the side "b" faces up-
ward as shown in the illustration.
Shift rod joint bolt
10 N·m (1.0 kgf·m, 7.2 lb·ft)
LOCTITE®
a
1
2
a. 27.4 mm (1.08 in)
6. Adjust:
• Installed shift rod length
Refer to "ADJUSTING THE SHIFT PEDAL"
on page 4-108.
b
a
b
1
7. Adjust:
• Drive chain slack
Refer to "Adjusting the drive chain slack" on
page 3-19.
Drive chain slack (Maintenance
stand)
25.0–35.0 mm (0.98–1.38 in)
Drive chain slack (Sidestand)
20.0–30.0 mm (0.79–1.18 in)
ECA13550
NOTICE
A drive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the swing-
arm or cause an accident. Therefore, keep
the drive chain slack within the specified lim-
its.
EAS31729
ADJUSTING THE SHIFT PEDAL
TIP
The shift pedal position is determined by the in-
stalled shift rod length.
1. Measure:
• Installed shift rod length "a"
Incorrect  Adjust.
Installed shift rod length
273.8–275.8 mm (10.78–10.86 in)
2. Adjust:
• Installed shift rod length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
4-108
CHAIN DRIVE
a