Yamaha MTN1000 2016 Service Manual page 105

1. Brake light relay
2. Main fuse
3. EXUP servo motor
4. Band
5. Tail/brake light
6. Tail/brake light coupler
7. Rear turn signal light coupler (right)
8. Rear turn signal light coupler (left)
9. Brake light relay lead
10.EXUP servo motor lead
11.Starter relay
12.Plate
13.License plate light lead
14.Tail/brake light lead
15.Rear turn signal light lead
16.Rear turn signal light resistor
17.Battery box 1
18.Positive battery lead
19.Battery box 2
20.Battery
21.EXUP cable 1
22.EXUP cable 2
23.Lean angle sensor lead
24.Lean angle sensor
25.Plastic locking tie
26.Rear turn signal light resistor lead
A. Insert the wire harness clamp into the hole in
the plate.
B. Insert the tail/brake light coupler into the hole
in the plate.
C. Make sure that the leads fastened with the
plastic locking tie are not routed along the
upper side of the rib.
D. Fasten the leads between these ribs with the
plastic locking tie.
E. Insert the rear right turn signal light coupler
(white) into the hole in the plate.
F. Insert the rear left turn signal light coupler
(black) into the hole in the plate.
G. Insert the starter relay until it comes into con-
tact with the plate.
H. Route the rear turn signal light leads,
tail/brake light lead and license plate light
lead through the ribs of the plate. Route the
rear turn signal light leads, tail/brake light
lead and license plate light lead on top of the
resistor. The routing order of the leads does
not matter.
I. Route the rear turn signal light resistor
between the ribs of the plate.
J. Route the lean angle sensor lead in between
the plate and EXUP cable 2.
K. Bottom of vehicle
L. Route the lean angle sensor lead in between
the plate and the projection on the rear
frame.
M. Projection on the rear frame
N. Install the lean angle sensor so that the "UP"
mark faces up.
O. The end of the plastic locking tie should face
toward the left side of the vehicle; cut off the
excess portion. The installation order of the
leads fastened with the plastic locking tie
does not matter.
2-60
CABLE ROUTING