Configuring Notifications - Spectracom VersaSync User Manual

4.3 Notifications
All available VersaSync events that can generate a notification to be sent are located under dif-
ferent tabs in the Notification Events panel: Timing , GPS , and System .
The VersaSync Events that can automatically trigger a notification are listed in the Event column.
It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable "SNMP" (to send out an SNMP trap)
Send an email to the address specified in the corresponding "Email Address" column.
4.3.1

Configuring Notifications

To configure Notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications . The Notifications screen will display:
It is divided into two panels:
182
Note: Whether or not notifications are enabled/disabled for a given event, the
occurrence of the event is always logged.
The Actions panel, featuring:
The SNMP Setup button: See "SNMP" on page 66.
The Email Setup button: Configure VersaSync's interface settings for
Exchange email servers and Gmail.
For more information on this subject, see the Spectracom Technical Note
Email Notification Setup
The Events panel, offering three tabs:
Timing : Events for Sync Status and Holdover, Frequency error, Input ref-
erences and the internal oscillator.
.
CHAPTER •
4 VersaSync User Manual Rev. 6.0