Spectracom VersaSync User Manual page 115

To access the NTP Expert Mode, navigate to MANAGEMENT > NTP Setup . The switch for the
NTP Expert Mode is in the panel NTP Services .
NTP utilizes the
indirectly performed by a user via the integrated configuration pages of the VersaSync Web
UI. However, it may be desired in certain circumstances to edit this file directly, instead of using
the web-based setup screens. When Expert Mode is enabled, the user has direct access to the
NTP.conf
CHAPTER •
2 VersaSync User Manual Rev. 6.0
Caution: Any configurations made in
Expert Mode is disabled.
file for its configuration. Normally, configuration of this file is
NTP.conf
file.
Caution: Spectracom Tech Support does not support the editing of the NTP con-
figuration files while in the Expert Mode. For additional information on editing
the file, please refer to
NTP.conf
Note: IMPORTANT: If an undesirable change is made to the
affects the NTP operation, the
long as the previous configuration was known.
The file can be reset back to the factory default values by either using the
NTP.conf
procedure to restore all of the VersaSync factory default settings (see "Restoring the
Default NTP Configuration" on page 82) or editing the file back to the original con-
figuration as shown in the factory default configuration below.
Caution: If changes are made to the
Expert mode should remain enabled from that point forward. Disabling Expert
mode after changes being made to this file may result in loss of this configuration
information.
2.7 Configuring Network Settings
NTP Expert Mode will be lost as soon as
http://www.ntp.org/
file can be manually changed back as
NTP.conf
file while in the Expert mode,
NTP.conf
NTP
.
file that
NTP.conf
103