Assigning A Static Ip Address - Spectracom VersaSync User Manual

2.5.1

Assigning a Static IP Address

There are two ways to setup a permanent static IP address, after connecting VersaSync to a
DHCP network:
Assigning a Static IP Address Using the CLI:
Open the serial console (e.g., by using TeraTerm)
1.
2.
3.
4.
Assigning a Static IP Address Using the Web UI:
1.
2.
3.
4.
CHAPTER •
2 VersaSync User Manual Rev. 6.0
Note: For your reference, the command
mands. Press the space
previous page. To leave the VI editor, press
Disable DHCP – Command:
respectively).
Set the static IP address – Command:
Example:
mask> ip4set 0 10.2.100.245 255.255.0.0
If required, also set your gateway address:
Verify that the address has been accepted – Command:
If so required, turn DHCP back on – Command:
Enter the assigned dynamic IP address obtained during setup ("Initial Network Setup" on
page 27) into the address field of your browser (on a computer connected to the Ver-
saSync network). If the network supports DNS, the hostname may also be entered instead
(the default hostname is "Spectracom"). The start screen of the VersaSync Web UI will be
displayed.
Log into the Web UI as an administrator. The factory-default user name and password
are:
Username :
spadmin
Password :
admin123
Disable DHCP by navigating to MANAGEMENT > Network Setup . In the Ports panel on
the right, click the GEAR icon next to the Ethernet Port you are using. In the Edit Ethernet
Port Settings window, uncheck the Enable DHCPv4 field. Do NOT click Submit or Apply
yet.
In the fields below the Enable DHCPv4 checkbox, enter the desired Static IP address, Net-
mask, and Gateway address (if required). Click Submit.
For subnet mask values, see "Subnet Mask Values" on the next page.
helpcli produces a list of available com-
key to display the next page, or the
Q or Ctrl C
( where x is 0/1 for ETH0 and ETH1 ,
dhcp4set <x> off
ip4set <x>.<IP address>.<subnet
gw4set <x> <gateway address>
dhcp4set [x] on
2.5 Setting up an IP Address
b key to display the
.
net
33