Spectracom VersaSync User Manual page 41

b.
For more detailed information about setting a static IP address for your unit, see "Setting up an
IP Address" on page 32
Next, proceed to "Accessing the Web UI" on page 31.
CHAPTER •
2 VersaSync User Manual Rev. 6.0
Note: The default login credentials are:
User name =
Password = admin123
If you are on a DHCP-enabled network, retrieve the IP address assigned to VersaSync
by typing the command. The command should return the network settings, includ-
net4
ing the IP address assigned to the unit. Take note of the IP address.
You can use this IP address to login to the VersaSync Web UI and then set a static IP
address, subnet mask and gateway. (This can also be done via the CLI and a terminal
emulator. See "Assigning a Static IP Address" on page 33).
Or, continue with the network configuration via the CLI, as described under Step c.
below.
Note: For your reference, the command
commands. Press the
display the previous page.
Should it become necessary to leave the VI editor mode (indicated
Note:
by a command line prompt ":"), press
spadmin
(will not be displayed on the screen)
helpcli
space key to display the next page, or the
Q , or
2.2 Initial Network Setup
produces a list of available
b key to
Ctrl C .
29