Configuring Inputs/Outputs - Spectracom VersaSync User Manual

Network Bits Equivalent Netmask Network Bits Equivalent Netmask
23
22
21
20
19
2.6

Configuring Inputs/Outputs

This Chapter covers the configuration of the inputs and outputs of the I/O connector.
When you configure an input our output via the I/O connector, you will need to adjust both
the pin configuration ("Assigning I/O Pins" on the next page) and (for some types) the settings
for that input or output via the Web UI ("Configuring I/O Settings" on page 40).
Figure 2-2:
For more information on the I/O connector, see "Connectors and their Pinouts" on page 8.
CHAPTER •
2 VersaSync User Manual Rev. 6.0
255.255.254.0 11
255.255.252.0 10
255.255.248.0 9
255.255.240.0 8
255.255.224.0
I/O connector
Note: The GNSS input reference
unit via the I/O connector and are therefore not explained in this Chapter; for
instructions on how to configure the GNSS reference, see "The GNSS Reference"
on page 147 in the Chapter MANAGING TIME.
Note: The Network Ports eth0
> Network Setup . For more information, see "Configuring Network Settings" on
page 54.
2.6 Configuring Inputs/Outputs
255.224.0.0
255.192.0.0
255.128.0.0
255.0.0.0
as well as the 10 MHz outputs are not fed into the
and eth1 can be configured under MANAGEMENT
35