Spectracom VersaSync User Manual page 123

2.
3.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the VersaSync CLI:
There are two GPSD utility programs already incorporated into VersaSync;
CGPS
via GPSD. Both commands use
CHAPTER •
2 VersaSync User Manual Rev. 6.0
the Gear Icon in the GPSD Service panel allows you to change the Service Port
information. If your GPSD setup changes and needs to be reconfigured within
your VersaSync, this is where you can reset the service port.
The Actions panel provides an option to restore the default configuration .
The Receiver Status panel lists the information required by the GPSD service:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Precision Stat-
istics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength, and Usage
for each satellite.
gpsdserviceportget
gpsdserviceportset
. Both can be used as commands within the CLI to view information currently being sent
CTL + C
– Displays the GPSD service port
– Sets the GPSD service port
to stop.
2.7 Configuring Network Settings
GPSpipe
and
111