Performing A Gnss Receiver Survey - Spectracom VersaSync User Manual

The following table illustrates the interdependence between Receiver Dynamics, Receiver Mode
(see "Selecting a GNSS Receiver Mode" on page 153) and receiver type:
Table 3-2:
Single Satellite
Standard
Mobile (with u-blox receivers)
Notes:
3.3.3.5

Performing a GNSS Receiver Survey

CHAPTER •
3 VersaSync User Manual Rev. 6.0
Mode Application
Standard stationary Yes: needs ≥ 4 satellites for
only 33 minutes continuously in
12-hour window
Single stationary Manually set position
only
Satellite
Receiver dynamics, ~modes, ~ dynamics, ~ types
Receiver Mode
The u-blox M8T receiver now uses
tionary to indicate it will not resurvey after reboot.
Note: This topic only applies to
mode NO surveys will be carried out since the position is updated continuously.
Survey?
(A) After any reboot, if the
Dynamics setting is set to
"Land
(B) If no previously carried
out survey has been found
after
(C) When the unit detects it
has
(D): After "Delete Position"
command was submitted
(A) On reboot, if no hand-set
position
(B) After "Delete Position"
command was submitted
Receiver Dynamics
Land
Sea
(Resurvey)
irrelevant irrelevant irrelevant
Land to indicate it will RESURVEY on reboot, and
stationary applications
3.3 Managing References
Receiver
(Re-)Survey – When?
Dynamics
Land
Resurvey
– Resurvey". Stationary
–
Resurvey
a reboot
been re- located
Stationary
is detected
Stationary
Air
(No Resurvey)
irrelevant
– in Mobile receiver
–
No
Sta-
157