Inserting Power Supply Ps - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Wiring
5.5 Inserting and labeling the power supply, interface module, and electronic modules
5.5.2

Inserting power supply PS

Installing the Power Supply PS
1. Hang the Power Supply nto the top of the mounting position of terminal module TM-PS-A/
TM-PS-A UC.
2. Swivel the Power Supply downwards until it latches on to the terminal module.
3. If your configuration has a power supply for redundancy, repeat steps 1 and 2 on terminal
module TM-PS-B/ TM-PS-B UC.
Figure 5-12
124
Installing the Power Supply PS
CAUTION
Danger of crushing!
Despite its small size, the Power Supply PS weighs 2.7 kg because it is compact.
Therefore, please make sure to hold the Power Supply PS firmly in your hand.
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP