Siemens SIMATIC ET 200iSP Operating Instructions Manual page 64

Configuration options
3.12 System configuration in RUN (CiR)
Requirements
● as of STEP 7 V5.3 SP2 with HW update 0042 (version V3.0)
● PCS7 will be released with the next service packs for PCS7 V6.1, V7.0 and V7.1.
What points should you note when planning the ET 200iSP stations?
● Construct the ET 200iSP station entirely using terminal modules and a terminating module.
● Add components to the ET 200iSP with the necessary electronic modules. Fill the remaining
slots with the reserve modules. All the reserve modules must be inserted and there must
be no gaps.
● You do not have to configure reserve modules.
Rules for making changes to the system while it is in use
● If you are modifying the real hardware configuration, there may be only one gap each. When
removing the electronic modules, replace the electronics modules by reserve modules;
when adding electronic modules, replace the installed reserve modules with electronic
modules.
● If you have fitted a slot cover on the last free slot, it is not expandable.
● Note that terminal modules TM-RM/RM are required for electronic modules 2DO Relay
UC60V/2A.
Example: Replacement of configured electronic modules
1. Replace the electronic modules or reserve modules with gaps in the configuration (HW
config).
2. Execute the Save and Compile menu command.
3. Download the station configuration to the H station in RUN mode.
4. Change the real hardware configuration: Remove and install one module at a time (for
example, remove slot 5 --> install slot 5). Note: two empty slots are not permitted.
5. Replace the gaps in the configuration (HW config) with the new electronic modules.
6. Execute the Save and Compile menu command.
7. Download the station configuration to the H station in RUN mode.
Result
The system modification was successfully completed.
64
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP