Siemens SIMATIC ET 200iSP Operating Instructions Manual page 4

Preface
Changes since with the previous edition
This manual contains the following changes/additions compared to the previous version:
● The terminal module TM-PS-UC can also be used for the PS DC 24V (as of ES07)
● The terminal modules TM-PS-A/B (DA10/DB10) can also be supplied as replacement parts
● The approvals have been updated.
Approvals
See section Standards and certifications (Page 195)
CE mark
See section Standards and certifications (Page 195)
Labeling for Australia (C-tick mark)
See section Standards and certifications (Page 195)
Standards
See section Standards and certifications (Page 195)
Position in the information landscape
In the section AUTOHOTSPOT you can find a list of additional information sources for SIMATIC
S7 and the ET 200 distributed I/O system.
Guide
This manual describes the hardware of the ET 200iSP distributed I/O station. It consists of
introductory sections and reference sections (technical specifications).
● Installing and wiring the ET 200iSP distributed I/O station
● Commissioning and diagnostics of the ET 200iSP distributed I/O station
● Components of the ET 200iSP distributed I/O station
● Order numbers
Special notes
The EC-type-examination certificate and EC certificate of conformity for the ET 200iSP
distributed I/O device are available from Service & Support on the Internet
www.siemens.com/automation/service&support)
4
(http://
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP