Installing The Mounting Rail - Siemens SIMATIC ET 200iSP Operating Instructions Manual

● The ET 200iSP is completed by the terminating module. The terminating module
accompanies the terminal module TM-IM/EM and/or TM-IM/IM. If your ET 200iSP
configuration leaves you with a gap in the last slot, you must install the slot cover or a
reserve module in this slot.
– Install a slot cover if the ET 200iSP will not be expanded in the future. The slot cover is
– Install a reserve module if you want to use the free slot for a future expansion (by means
● The maximum configuration of the ET 200iSP distributed I/O station is one power supply,
one interface module and 32 electronic modules. Remember not to exceed the maximum
current consumption.
Note
Due to integrated coding, the terminal modules can only be installed in the order described.
4.2

Installing the mounting rail

Properties
The ET 200iSP distributed I/O station is mounted on a rail for S7 installation technology (Refer
to appendix "Order Numbers"). These rails are ready to install and have 4 holes for the securing
screws and a grounding bolt.
The following configuration is recommended for optimal use of the rail when mounting the
terminal modules.
ET 200iSP
Operating Instructions, 11/2017, A5E00247483-07
integrated in the terminating module.
Replacing the slot cover with an electronic module during operation will cause a station
failure of the ET 200iSP.
of an electronic module).
Installing
4.2 Installing the mounting rail
91