Identification Data I&M - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Configuration options
3.10 Identification data I&M
Example
The schematic below illustrates the direct data exchange "relationships" that you can configure
with an ET 200iSP as publisher and which nodes can "listen in" as potential recipients.
Figure 3-4
3.10 Identification data I&M
Properties
I data: Information about the module that is normally printed on the enclosure of the module.
I data is read-only.
M data: System-specific information such as the installation location and date. M data is
generated during configuration and written to the module.
Identification data (I&M) this information stored on a module that supports you when
● Troubleshooting in a system
● Checking the system configuration
● Locating hardware changes in a system
Reading and writing the identification data with STEP 7
HW Config shows the I&M in the "Module status - IM 152" and "Properties - DP Slave" tabs.
For information, refer to the STEP 7 Online Help.
Reading and writing the I&M with SIMATIC PDM
With SIMATIC PDM you can read the parameters and I&M by choosing the File > Complete
Download to PG/PC menu command and write them by choosing the Device > Complete
Download to Device menu command.
58
Example of Direct Data Exchange
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP