Siemens SIMATIC ET 200iSP Operating Instructions Manual page 126

Wiring
5.5 Inserting and labeling the power supply, interface module, and electronic modules
3. Label the module using the label strips provided.
4. Then insert the label strips in the interface or electronic module.
Figure 5-13
Make sure that the terminal and electronic module are properly allocated for their application.
Note
If any gaps (of an electronic module) develop due to the ET 200iSP configuration, the following
rules apply:
● The gap is at the last slot of the ET 200iSP: insert the slot cover (or a reserve module) in
this gap.
● The gap is at a different slot (for electronic modules): insert a reserve module in this gap.
126
Installing and labeling interface and electronic modules
WARNING
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP