Siemens SIMATIC ET 200iSP Operating Instructions Manual page 208

Terminal modules
9.3 Terminal modules TM-IM/EM 60S and TM-IM/EM 60C
Properties
● Terminal module for an interface module (left-hand side) and an electronic module (right-
hand side)
● PROFIBUS RS 485-IS connection via 9-pin Sub D socket
● Connection of actuators and sensors by means of screw terminals for TM-IM/EM 60S
● Connection of actuators and sensors by means of spring terminals for TM-IM/EM 60C
● Self-generating interference leakage from the terminal module to the mounting rail by
means of a spring contact
● Prewiring of the terminal module is possible
Note
The spring contact to the mounting rail connects the cable shield of the PROFIBUS-DP
cable with the equipotential bonding PA during operation.
Pin assignment
Table 9-4
208
Pin assignment on the TM-IM/EM
View
1
2
3
4
5
6
7
8
9
Pin assignment, see sections "AUTOHOTSPOT" and "AUTOHOT‐
SPOT"
Terminal
PA Equipotential bonding
- -
RxD/TxD-P Data line B
- -
ISGND Bus termination ground
ISP Bus termination P
- -
RxD/TxD-N Data line A
-
Operating Instructions, 11/2017, A5E00247483-07
Name
ET 200iSP