Installing The Slot Number Labels - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Removing the slot cover
1. Push the screwdrivers into the lower opening on the slot cover and lever this out of the
terminal module.
2. Press the Slot Cover into the bracket on the terminating module.
Figure 4-12
4.6

Installing the Slot Number Labels

Properties
The slot number plates identify the individual electronic modules with a slot (1 to 34).
Requirements
● The terminal modules are installed.
● There must not be any electronic modules inserted when you apply the slot number plates.
● Position terminal module TM-PS-A/ TM-PS-A UC: One plate at the top left
Position of terminal modules TM-IM/EM, TM-EM/EM, and TM-RM/RM: One plate at the top
left and right.
Required tools
3.5 mm screwdriver (for removal only)
ET 200iSP
Operating Instructions, 11/2017, A5E00247483-07
Installing the slot cover
4.6 Installing the Slot Number Labels
Installing
101