Siemens SIMATIC ET 200iSP Operating Instructions Manual page 156

Commissioning and Diagnostics
6.8 Diagnostics with STEP 7
Digital output module 2 DO Relay UC60V/2A
Table 6-12
Diagnostic message
Error
Analog input modules
Table 6-13
Diagnostic message
Short circuit
Wire break
Upper measuring range exceeded
Lower measuring range exceeded
Error
Reference channel error
Not possible with 4 AI TC and with 4 AI I 4WIRE HART
1
Analog output modules
Table 6-14
diagnostic message
Short-circuit
Wire break
Error
Diagnostic message only with currents > 1 mA.
1
Watchdog module
Table 6-15
Diagnostic message
Error
Actions after diagnostic message in STEP 7 or DPV1 Operation
Each diagnostic message leads to the following actions:
● In S7 or DPV1 operation, diagnostics are reported as diagnostic interrupts.
● In DPV1 operation, diagnostics are also reported when CPU is in STOP state.
156
Digital output module 2 DO Relay UC60V/2A
Applicability
Module
Analog input modules
1
Analog output modules
Applicability
1
Channel
Channel
Module
Watchdog module
Applicability
Module
Can be set
No
Applicability Can be set
Channel Yes
Channel Yes
Channel Yes
Channel Yes
Module No
Module No
Can be set
Yes
Yes
No
Can be set
No
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP