Siemens SIMATIC ET 200iSP Operating Instructions Manual page 261

Parameters
Chatter monitoring: Number
of signal changeovers
2
Can only be assigned in HW Config and if the ET 200iSP is being operated as an S7 DP slave.
1
Parameter cannot be set unless chatter error diagnostics is enabled.
2
Parameters for 8 DI NAMUR, "2 Count/ 6 DI NAMUR" or "2 Count/ 6 Control" configuration
The following parameters can be set for the counter in addition to the "8 DI NAMUR"
configuration:
Table 12-18 Parameters for "2 Count/ 6 DI NAMUR" and "2 Count/ 6 Control"
Parameters
Sensor type counter inputs ● Channel disabled
Mode for counter 1
Mode for counter 2
Parameters for 8 DI NAMUR, "2 Count/ 6 Control" configuration
The following parameters can be set for the counter in addition to the "8 DI NAMUR"
configuration:
Table 12-19 Parameters for "2 Count/ 6 Control"
Parameters
Control channel
ET 200iSP
Operating Instructions, 11/2017, A5E00247483-07
Range of values
2 to 31
Range of values
● NAMUR sensor
● Single contact, no load
resistance
● Standard counting function
● Periodic counting function
● Cascaded counting function
● Standard counting function
● Periodic counting function
Range of values
● Channel disabled
● NAMUR sensor
● Single contact, no load
resistance
12.5 Parameters of the digital electronic modules
Default
5
Default
NAMUR sensor
Standard counting function Channel 0
Standard counting function Channel 1
Default
NAMUR sensor
Digital electronic modules
Applicability
Channel
Applicability
Channel
Applicability
Channel
261