Basic Settings For Fieldbus Communication - Festo CTEU-DN Description, Functions And Maintenance

2. Installation and interfaces
Fieldbus adapter
Bus connection
FBA-1-SL-5POL
with FBSD-KL-2X5POL
1 2 3 4 5
Fieldbus adapter
3)
FBA-CO-SUB-9-M12
Fieldbus adapter
FBS-SUB-9-BU-2x5PIN-B
Fieldbus adapter
FBS-SUB-9-WS-CO-K
1)
Protective cap or plug with bus termination resistor required if connection remains unused
2)
Use cables with a minimum cross-section of 0.34 mm
3)
When using standard sub-D plugs to IP20: Connecting screws with UNC female thread required for
mounting (type UNC 4-40/M3x6)
Tab. 2/5: Fieldbus adapter (bus connection/plug-adapter) - Part 2

2.2.6 Basic settings for fieldbus communication

2-12
2)
The following basic settings for fieldbus communication must
be made using the DIL switches on the bus node (
below):
– DeviceNet address ("Station number")
– Data rate (baud rate)
Pin Allocation
1 Power supply to bus (0 V)
CAN_L
2
3 Functional earth (FE)
4 CAN_H
5 Power supply to bus (DC 24 V)
Assembly instructions
FBA-CO-SUB-9-M12
Assembly instructions
FBS-SUB-9-BU-2x5PIN-B
www.festo.com
2
Festo P.BE-CTEU-DN-OP+MAINT-EN en 1206NH
Support Portal
Sections