Festo CTEU-DN Description, Functions And Maintenance page 35

2. Installation and interfaces
Example 1:
Station number 05
1 2 3 4 5 6
1
Tab. 2/6: Setting example for DeviceNet address ("Station number", DIL switch
group 1)
Festo P.BE-CTEU-DN-OP+MAINT-EN en 1206NH
– Diagnostic functionality (transmission of diagnostic in-
formation to the process data or access to diagnostic in-
formation exclusively via Explicit Messaging)
– Fail state and idle state mode
To set the DIL switches, you must remove the cover:
Removal of the DIL switch cover
Proceed as follows:
1. Switch off the power supply.
2. Unscrew the two mounting screws of the transparent
cover and remove the cover.
Setting the DIL switches
Proceed as follows:
1. Assign to the bus node a station that has not yet been
allocated see examples below for setting the binary-
coded DeviceNet address ("Station Numbers") per DIL
switch group 1
Example 2:
Station number 38
1
Tab. 2/6.
2 3 4 5 6
1
2-13