Configuration - Barco TransForm A series User Manual

X terminal, video wall controller

Table of Contents

3.4.2 X.11 configuration

For the X.11 configuration of T

configuration purposes with the following keys pressed simultaneously:

Now, back in line mode log in as root! The factory set password for root is barco:

eos login: root

Password: barco

Configuration can be carried out by means of the configuration script EOSconfig. To start this script, change the

directory first:

eos:/root # cd /opt/MMT2686/config/

then execute the script:

eos:/opt/MMT2686/config # ./EOSconfig

EOSconfig will guide you through the configuration. You can exit configuration without saving the modifications

at any time by pressing simultaneously:

<Ctrl> C

Thus all parameters entered up to now were deleted again. It is more convenient however to check all data nec-

essary for configuration first and then start the script. Therefore you are recommended to read through the fol-

lowing pages of this section before starting the configuration.

Below you can read through a typical course of the configuration script expanded with comments giving more

details.

Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006

A the script call must be entered in line mode. Therefore leave X.11 for

RANS

ORM

3. Getting started

_____________________________________________________

3-50

Table of Contents