Barco TransForm A series User Manual page 142

Restore procedure
Whenever it is necessary to go back to a saved configuration or to restore the working partition, one out of two
possible procedures can be performed.
Either:
•
When booting T
RANS
menu when the system comes up, please refer to section
soon as the lilo prompt appears. This is dependent on the settings chosen by means of the boot loader
utility, please refer to section
Or:
•
When T F A is running, enter into the command line service eosxs with the option restore to
RANS ORM
boot from the backup partition:
service eosxs restore
In both cases you have to be logged in locally on the T
Before the restore procedure actually starts, date and time of the backup is displayed and you will be prompted
to confirm the restore procedure by typing y.
Following that, the T
RANS
working partition that is stored on the backup partition to the working partition. This means that the currently
used working partition becomes overwritten. When copying is finished, T
time it boots from the working partition and is therewith operable again, based on the state of system and con-
figuration from the time of the backup.
Whenever booting from the backup partition the content of the working partition becomes
overwritten with the backup. This means the current content of the working partition gets
lost!
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
F A the option backup can be selected. It either must be selected from the graphical
ORM
4.8.3 Boot loader
F A boots from the backup partition. After booting it copies back the version of the
ORM
3.3.2 Switching on
utility.
F A and the X server must not be started.
RANS ORM
or the option must be typed as
F A reboots automatically, this
RANS ORM
_____________________________________________________
4. Operating
4-61