Table of Contents
Advertisement
Setting the Eos FireWall Policies
=================================
If you want to configure the Eos as secure
X Terminal, choose the policy "high"
then only X11-Connection are permitted
Choose one of the FireWall Policies
-----------------------------------
1 - "High"
2 - "Medium"
3 - "Disable"
4 - "Don't change the existing FireWall Policy"
Enter the FireWall Policies
You have chosen the FireWall Policy "Medium"
Is this correct? (yes/no)? [yes]:y
Finishing the configuration
If you do install a monolithic T
When configuring a distributed system you have to specify the data for the central device and the rendering
machines. See section
3.4.3 Configuring a distributed
*************************************************
*
*
The X Server configuration is finished now,
*
please enter your choice
*
*************************************************
1
Exit configuration (all your current entries will be lost)
2
Finish configuration
Enter your X Server Configuration
Configuring the X Server.
***************************************************************
Multiscreen X Server setup done... Have fun!
NOTE: enter "service mmtserv"
to start the X Server
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate TransForm A in eXtended safety boot mode, please take care to update the
backup partition after successful configuration, see section
(eosxs
Utility).
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
[2]: 2
F
A, configuration is done and the script is finished with the next step.
RANS
ORM
system.
[2]:2
Please wait ...
*
*
*
*
4.8.5 Backup and restore procedures
_____________________________________________________
3. Getting started
3-57
Advertisement
Table of Contents
