Barco TransForm A series User Manual page 108

Encoder
manufacturer – type
Verint – S1700e
VideoLAN – VideoLAN (VLC/VLS)
Visiowave – Evolution
Visiowave – Visiobox
Vorx – VON v1.0
For some encoders the settings are not defined, if there are difficulties to set them, please
contact the Barco support, see section
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
compression IP
algorythm protocol
Startstring example: SmartSight
Only with encoder firmware 3.20 build 444. Usage of S1700e recommend.
mpeg4 RTP
startstring example: SmartSight
mpeg2 –
mpeg4
mjpeg
For IP protocol multicast, unicast, UDP or RTP is possible.
2D wavelet UDP
Use the encoder TCP port for TCP,
Startstring example: Evolution
Signaling method is TCP, signaling is supported.
2D wavelet UDP
Startstring example: Visiobox
Encoder firmware 2.2.4 currently not supported, in case you want to use it
please contact the Barco support
mpeg2 UDP
Decoding of AES streams is not supported.
8.3 Hot
Skip bytes Skip bytes
at start at end
0 0
0 0
0 0
0 0
8.3 Hot line.
0 0
Encoder dependant parameter values
line.
_____________________________________________________
4. Operating
Stream TCP PID
protocol
auto ON 0
auto OFF –
auto ON 0
auto ON 0
auto OFF 0
Table 4-9
4-27