Barco TransForm A series User Manual page 62

After switching on the P
first graphic card.
When switching on the central Processor of a distributed system this text is displayed on the
connected monitor.
The other displays show their respective bus and slot no., e. g.:
PCI Bus: 2, PORT: 1
There are two possible boot modes for T
section 6.1.1 Boot modes. The operation of T
Normal boot mode
After a few minutes the graphical user interface X.11 appears without user interaction.
eXtended safety boot mode
The T F A startup screen comes up. Select linux to boot from the working partition.
RANS ORM
If you select backup, the restore procedure is started and the working partition becomes
overwritten with the backup system, which might lead to a loss of current data, depending
on the state of the backup, please see section
After a few minutes the graphical user interface X.11 appears.
Configuration
If software configuration has already been carried out you can go on with chapter
configuring T F A in section
RANS ORM
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
boot information is displayed on the graphic device connected to port 0 of the
ROCESSOR
F
RANS ORM
F
RANS ORM
3.4 Configuration
A. Normal boot mode and eXtended safety boot mode. See
A differs a little, depending on this mode.
4.8.5 Backup and restore procedures (eosxs
software.
3. Getting started
T F
RANS ORM
4 Operating. Otherwise proceed
_____________________________________________________
Utility)!
Figure 3-54
A startup screen
3-44