Table of Contents
Advertisement
Configuring video streams
The parameters of a video stream must be defined in the SVC Stream Params Editor, before the S
C
can display it. Once defined it is available for every S
ARD
Stream Params Editor select SVC Pref ... -> Stream Settings from the File menu, please refer to section
The Xvideo
client.
Pressing the Add button adds a new stream with the entered name into the Streams list. The parameters that
are displayed at that time are saved together with it. If there exists already an entry with the same name then
its parameters are not changed. Pressing the Apply button applies the displayed parameters to the hardware. In
that way changes can be controlled directly. Pressing the OK button applies the parameters to the hardware and
to the system. Pressing the Cancel button closes the window, anyhow changes that are already confirmed with
the Add or Delete button can not be revoked.
A list of all video streams in alphabetic order
Stream
Decoder Control
select the type of stream (
IP Address
when
Encoder port, appendant to the IP address.
Port
Selection of the used IP protocol.
IP Portocol
(firmware < 2.0 of the S
Stream Protocol
auto
elementary
program
transport
Should be entered for transport streams when the PAT (program allocation tables) or
PID
PMT (program map tables) are not sent.
0 is a predefined value. It causes an auto-search for the video PID. If no valid PID is found
no video will be shown.
Skip bytes at ...
Encoder dependant value of the number of bytes that must be skipped at the beginning
Start
/ end of each packet, please see table below.
End
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
unicast
is selected also the multicast IP address must be specified
multicast
TREAMING
Auto-detection of the stream protocol
Elementary stream
Program stream
Transport stream
V
C
TREAMING
IDEO
ARD
,
or
)
broadcast
multicast
V
C
only supports
IDEO
ARD
_____________________________________________________
4. Operating
TREAMING
in the system. To open the SVC
)
UDP
V
IDEO
4.6.3
4-24
Advertisement
Table of Contents
