Barco TransForm A series User Manual page 65

Network configuration
Select Config : Networking : Client Tasks : Host name and IP network devices.
Up to four network cards are automatically detected during the system installation. This means the settings for
net device and kernel module are correct if the cards have been present during installation. If a card is inserted
afterwards also these settings have to be adopted. The drivers (Setting: Kernel module) for the different net-
work cards are:
driver network card
eepro100 Ethernetcard 100 Mbps, PCI
e100 Ethernetcard 100 Mbps, PCI
e1000 Ethernetcard 1000 Mbps, PCI
e1000 onboard LAN adapter (AGS-3328-2 and higher)
bcm4400 onboard LAN adapter (AGS-3328-1 and lower)
bcm5700 onboard LAN adapter (AGS-3389-0 and higher)
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
3. Getting started
redundancy
no
possible
possible
no
no
no
_____________________________________________________
Figure 3-55
3-47