Table of Contents
Advertisement
The back
24
25
26
9
link interface card
10
CPU board
11-22
Barco's expansion cards
23
ventilation slots
24
mains connection of power module
25
LED: power status of power module
permanent red
permanent green
off
26
connection for equipotential bonding conductor
In total there are 14 card slots visible from the back, with the left two positions having a fixed assignment for
the link interface card [9] and the CPU board [10]. Graphic cards, OmniScalers and input cards [11-22] follow,
depending on the configuration of T
On the left there are three power modules each with a mains connection [24] and a LED to indicate the power
status [25]. On the lower part there is a connection for the equipotential bondig conductor [26].
To disconnect the O
the mains connection [24]. Therefore the back panel has to be easily accessible!
To protect the O
kept free of obstructions!
To ensure power redundancy take care to connect each of the power modules to an
independent power net.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
23
9
10
standby mode: Power applies at the module but the device is not
switched on.
power module OK, power output OK
power connection is interrupted
F
A.
RANS
ORM
B
A12 from the power supply all power cords have to be pulled of
MNI
US
B
A12 from overheating, the air supply openings in the case shall be
MNI
US
11-22
______________________________________________________
3. Getting started
23
Figure 3-8
Rear view of O
B
A12
MNI
US
3-7
Advertisement
Table of Contents
