Table of Contents
Advertisement
Finishing the configuration
****************************************************************
Distributed
NOTE: enter "service mmtserv"
to start the Distributed X Server
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate TransForm A in eXtended safety boot mode, please take care to update the
backup partition after successful configuration, see section
(eosxs
Utility).
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
X Server setup done... Have fun!
3. Getting started
4.8.5 Backup and restore procedures
_____________________________________________________
3-61
Advertisement
Table of Contents
