Table of Contents
Advertisement
Input Settings
Auto
Sync Level
Position
Size
Phase
PLL Devider
Info
Registry
Clear Name
Append
Insert
Replace
Delete
Clear all
Save
Reload
Import
Add
Clear Select
Dismiss
If the applied signal changes while
adjusting the settings, then a warning
message apears, please see below. You
can change to the contol tab and select an
appropriate timing for the new signal
(click YES).
It is also possible, that the system detects a new timing, if the settings have been displaced
too much. In this case click NO and readjust the settings again.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
Auto adjustment of source
Determine the sync level of the signal
HV:
tuning the horizontal/vertical sync level
SoG:
tuning the Sync on Green level
Position display area of visible RGB signal in the Canvas Panel
H:
horizontal position of first active pixel (in steps of two)
V:
vertical position of first active line
Determine size of visible RGB signal
H:
number of active pixels per line (in steps of four)
V:
number of active lines
Tune phase shift of ADC
Determine pixel frequency of RGB input
Information about input signal
V_Tot: number of lines
V_Freq: frame rate
Sync:
mode of synchronization
Clear text box, which displays name of current preset
Current setting is added to the list of presets
Current setting is inserted in the list of presets (before the highlighted preset)
Replace highlighted preset by current setting
Delete highlighted preset
Delete all listed presets
Save all listed presets in preset file
Reload preset file and discard changes
Add all highlighted presets to list of presets
Clear selection
Dismiss dialog box
_____________________________________________________
4. Operating
Figure 4-10
4-30
Advertisement
Table of Contents
