Network Reporting Utility (Procfg) - Barco TransForm A series User Manual

4.8.7 Network reporting utility (procfg)

The procfg utility serves to gain information about the configuration and state of the network cards. It can be
used for network cards that use the driver e100 or e1000, please refer to section
information can be requested as follows:
procfg [-<option>]
The following command line options are the most useful:
option argument
meaning
blink eth<nr> -t <seconds>
The LED on the Ethernet card with the specified number <nr> starts fast blinking for
10 seconds. If -t is indicated the LED blinks during the specified time interval.
tree
Displays an overview about the inserted network cards including an AFT team.
teams
lists name and mode of the team and information about its primary adapter, please
refer also to section
-m
lists all members of the team and their current properties.
-i
lists interface name, IP address, netmask, broadcast and state of the team members.
-p
lists the load time parameters and values of the team members.
adapters -a
Information about the link state, speed and duplex of the network cards and AFT
teams is displayed.
More information about procfg can be found in the manual pages. The manual pages can be read by entering
man procfg into the command line.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
value
6.1.7 Redundant network adapter.
3.4.1 System configuration. The
Options of the procfg utility
_____________________________________________________
4. Operating
Table 4-48
4-63