Barco TransForm A series User Manual page 67

Keyboard
Select Control : Features. The Features tab opens. Here is the keyboard map that provides the different keyboard
types. You have also the possibility to choose the language in which the dialogs are held. Hit Accept when fin-
ished.
Time (optional)
If T F A is just used as X-terminal, it does no date & time related processing.
RANS ORM
Select Control : Date&Time. Adjust T
User accounts (optional)
As T F A comes preconfigured with user <mmt> and password <mmt> usually defining an additional user
RANS ORM
account is not required.
Select Config : Users accounts : Normal : User accounts. This will open the Users accounts tab.
If you have more than 15 accounts on the system, Linuxconf will provide you with a filter screen. You can use
this to select a smaller range of accounts than the full list. To get the full list, select Accept without changing any
of the parameters.
Select Add. This will open the User account creation tab.
The User account creation tab is where you enter all the information on the new account. It has a number of
fields; only the login name is required, though filling in the Full name field is strongly recommended. Once you
have entered the login name and any other desired information select the Accept button. If you decide against
creating a new user, hit Cancel instead.
Upon hitting Accept the configuration program will prompt you to enter the password. There is also a field called
Confirmation where you will need to type the password again. Passwords must be at least 6 characters in
length. They may contain numbers as well as a mix of lowercase and uppercase letters. Hit Accept when fin-
ished.
Changing a user's password (optional)
Select Config : Users accounts – Normal – User accounts. This will open the Users accounts window. Select the
account whose password you wish to change. This will open the User information window. Select Passwd from
the options at the bottom of the screen.
The configuration software will then prompt you to enter the new password. There is also a field called
Confirmation where you will need to type the password again. This is to prevent you from mistyping the pass-
word. Passwords must be at least 6 characters in length. They may contain numbers as well as a mix of lower-
case and uppercase letters. If you decide against changing the password, just hit Cancel. Once you have entered
the new password select Accept.
You have to reboot TransForm A to make changes become effective.
If you operate TransForm A in eXtended safety boot mode, please take care to update the
backup partition after successful configuration, see section
(eosxs Utility).
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
F A to your time and confirm with Accept.
RANS ORM
3. Getting started
4.8.5 Backup and restore procedures
_____________________________________________________
3-49