Table of Contents
Advertisement
To set up networking, enter the IP address and netmask and if needed a default gateway and the primary name-
server and confirm with OK. If in doubt about the network settings ask your network administrator for the values.
When navigating through the dialog and leaving empty the fields for the default gateway or primary name
server, there will be default values entered automatically into the empty fields. To overcome this the F12 key
can be pressed instead of the OK button.
When the installation is finished you are prompted to press the <Enter> key to reboot T
The system will reboot now. Remove the CD from the drive as soon as the drawer ejects it. After this system
installation you have also to run through
distributed system through
logical
screens.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
3.4.1 System configuration
3.4.3 Configuring a distributed system
6. Advanced configuration
RANS
and
3.4.2 X.11 configuration
or
3.4.4 Configuring a distributed system with multiple
______________________________________________________
Figure 6-6
F
A.
ORM
Figure 6-7
and if you have a
6-5
Advertisement
Table of Contents
