Omnibus - Barco TransForm A series User Manual

3.2.15 OmniBus

Connecting to the host
The data connection between P
respective link interface card in the P
[9] (Figure 3-8) and in the OmniBus A18 [6]
The cable between host and OmniBus is fragile. It may not last under tension, or being bent
or twisted.
Connecting several OmniBus devices
In the P AGS-3389 there are four PCI slots for link interface cards available. With AGS-3328 five link inter-
ROCESSOR
face cards can be used. The respective number of O
B is connected in the manner explained above.
US
Order
The link interface cards are inserted in the PCI slots of the P
the lower numbers. If more than one O
The Processor expects the primary graphic adapter in the first OmniBus. Therefore the
OmniBus that is connected to the link interface 1 must be equipped with graphic cards.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
and O B is established with a link interface cable. It connects the
ROCESSOR MNI US
[19-24] (Figure
ROCESSOR
(Figure 3-11) respectively with a round cable.
B
MNI US
B is connected, they are numbered in the sequence of the PCI slots.
MNI US
Link Link
Inter- Inter-
face face
2
1
PCI 1 PCI 2 PCI 3 PCI 4
3-5) with the link interface card in the O
round cable for connection of host and O
devices can be connected to one P
following the network cards in the slots with
ROCESSOR
Link Link
Inter- Inter-
face face
3
4
Link interface cards in host to connect to multiple O
_____________________________________________________
3. Getting started
B A12
MNI US
Figure 3-42
B
MNI US
. Each O
ROCESSOR MNI-
Figure 3-43
B devices
MNI US
3-33