Barco TransForm A series User Manual page 106

This section contains data that is used, if initial communication with the encoder is
Encoder Control
needed to prompt the encoder to send a stream. All fields must be filled in!
IP address of the encoder; may only be filled in if TCP has been selected for IP Protocol
IP Address
Port where the encoder listens to TCP start commands; may only be filled in if TCP has
Port
been selected for IP Protocol
Should remain udp, as indicated in the section Decoder control above. Only if a commu-
IP Protocol
nication with the encoder is required, tcp should be selected.
String that is sent to the specified encoder
Startstring
As unicast streams are only sent to one single IP address, only one Streaming Video Card at
a time is able to display one particular unicast stream.
The following table lists the encoder specific values that must be entered into the Streams Params Editor. They
are valid with S
TREAMING
Encoder
manufacturer – type
AXIS – 241Q
BOSCH – Videojet 10 / Video-
jet 1000 / Videojet Xpro /
VideoJet8008 / VIP 10 /
VIP 1000 / VIP X1 / VIP X2
BOSCH – Videojet 1000 / Video-
jet 8000 / Videojet Xpro /
VIP 1000
Coretec – VCX-2400-E
Cornet –
iVDO Streamer 2/4 Encoder
Cornet –
iVDO Streamer 2/4 Encoder
DVTeL – 7601e
Exterity – A/V server
Fast Video Security – ENC 8M2
iMPath – i1000
iMPath – i4000
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
V C with firmware 4.1.3.5.
IDEO ARD
compression
algorythm
mjpeg
use port 80 for TCP and indicate the encoder IP address,
Startstring example: Axis241Q://GET /axis-cgi/mjpg/
Signaling method is http, signaling is supported.
A maximum use of 4 4CIF streams with a maximum quality of 75% (or at
least 25% compression) is recommended.
h263
No on-board RCP+ support; I-frame distance may not be 0.
mpeg2
No on-board RCP+ support.
mpeg2
mpeg2
mpeg4
mpeg4
Use port 3000 for TCP,
Startstring example: SmartSight
mpeg2
IP protocol:
for Transport/RTP and Elementary = RTP
SkipAtStart: for Elementary = 4, else = 0
mpeg2
mpeg2
mpeg2
RTP or UDP has to be configured in accordance with the encoder configuration.
IP Skip bytes Skip bytes
protocol at start at end
UDP 0 0
video.cgi?camera=1 HTTP/1.0\n\n
RTP 0 0
RTP 4 0
UDP 0 0
UDP 0 0
RTP 0 0
RTP 0 0
RTP/UDP 0 (4) 0
for Transport/UDP = UDP
RTP 4 0
UDP 0 0
RTP/UDP 0 0
_____________________________________________________
4. Operating
Parameters on the SVC Stream Params Editor
Stream TCP
protocol
auto ON
auto OFF
auto OFF
auto OFF
auto OFF
auto OFF
auto ON
auto OFF
auto OFF
auto OFF
auto OFF
Figure 4-7
PID
0
0
0
0
0
0
0
0
0
0
0
4-25