Barco TransForm A series User Manual page 66

The section Adaptor 1 treats the network options of the LAN connection of T
selecting and editing them. If you are putting T
address to your own.
Take care to insert the same sub net IP address in the configuration for a distributed system
as explained in section
The section Adaptor 2 treats the network options of the subnet, used with the distributed
system.
For the sub-net network card of the central unit, IP addresses must be specified.
Use the IP addresses 192.168.60.xxx as long as it will not collide with any other subnet within the Internet.
Select 192.168.60.254 for the central processor. This enables the numbering of the rendering machines
consequently with 1, 2, 3, etc. Clarify the corresponding Netmask addresses with your network administrator. In
the field Primary name + domain insert eos-core.
Confirm your changes with Accept or leave with Cancel.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
F A into operation you have to change the pre-adjusted IP
RANS ORM
3.4.3 Configuring a distributed
F A. You can change them by
RANS ORM
system.
_____________________________________________________
3. Getting started
Figure 3-56
Figure 3-57
3-48