Table of Contents
Advertisement
2
- DirectColor
Enter the Visual Class [1]: 1
IP address for engine 2 [192.168.1.2]:
Ethernet address for engine 2 [00.00.00.00.00.00]: 00.a0.c0.83.54.77
Screen arrangement for engine 2 (Width x Height) [2x4]: 2x2
Position for engine 2 (X,Y) [0,0]: 2,0
Graphic card type for engine 2
1 - "AGX-3000"
2 – "AGX-3281"
Enter the graphic card type
Configuring the Depth Resolution (Bit Per Pixel)
–----------------------------------------------
1
- for
8 bpp (256 colors)
2
- for 16 bpp (64K colors)
3
- for 32 bpp (16M colors)
Enter the Depth Resolution [3]: 2
Configuring the Visual Class
–--------------------------
A visual class describes the characteristics of a virtual colormap,
that has been or can be created for use a particular screen
The following visual class are supported.
1
- TrueColor
2
- DirectColor
Enter the Visual Class [1]: 2
These are your MLS Server settings
==================================
- Core machine's second IP:
- Engines Netmask Address:
- Operational mode :
- Number engines :
- Values for engine 1:
- Values for engine 2:
Everything correct? (yes/no)? [yes]:
Finishing the configuration
After specifying the parameters for multiple logical screens the values explained in section
and section
3.4.3 Configuring a distributed system
****************************************************************
MLS X Server setup done... Have fun!
NOTE: enter "service mmtserv"
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate TransForm A in eXtended safety boot mode, please take care to update the
backup partition after successful configuration, see section
(eosxs
Utility).
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
(read/write visual)
[1]: 2
(read only
visual)
(read/write visual)
192.168.1.254
255.255.255.0
Contiguous
2
IP = 192.168.1.1 Ether = 00.a0.c0.83.76.98
arrangement = 2x2
AGX-3281: Bpp = 16
IP = 192.168.1.2 Ether = 00.a0.c0.83.54.77
arrangement = 2x2
AGX-3281: Bpp = 16
must be indicated.
to start the EOS Distributed X Server
position = 0,0
Visual = TrueColor
position = 2,0
Visual = DirectColor
4.8.5 Backup and restore procedures
_____________________________________________________
3. Getting started
3.4.2 X.11 configuration
3-63
Advertisement
Table of Contents
