3. Install the new roller and bearing, using the retained shoulder bolt.
Docking Station AC Power Fuse
NOTE: The current version of the docking station uses a thermal fuse, built into the
power switch. There are no user-serviceable fuses.
NOTE: The following procedure only applies to legacy docking stations.
The only user-serviceable fuses are in the docking station. The two external AC fuses are loc-
ated between the power switch and the AC power plug.
Symptoms: When the docking station is switched on, the blue power light does not come on.
(Verify that the unit is plugged into AC power.)
Chapter 8: Maintenance
Figure 8-8. Docking Station Roller and Switch Locations
LD Platform User's Guide, 11970-000 Rev E
Page 111 of 142
Switch
Roller