3. Lower the docking station down, so the two bolts on the back of the docking station
slide into the bracket, to secure the docking station to the wall.
Floor-mount, without Floor Plate
Screw the base of the docking station directly to the floor, using three user-supplied screws. For
dimensions of the available holes in the base, refer to Figure 3-16. We recommend M5 self-tap-
ping or M4 sheet rock screws for this.
Floor-mount, with Floor Plate
This mounting method uses the floor plate. The floor plate is not shipped attached to the dock-
ing station, so you must attach it for this type of mount. It will be in the crate with the plat-
form, right behind the docking station.
Attaching the Floor Plate
Refer to the following figures.
Chapter 3: Setup
Figure 3-17. Rear View of Docking Station with Wall Bracket
LD Platform User's Guide, 11970-000 Rev E
Page 40 of 142