Configuring The Lis - Procleix TIGRIS Operator's Manual

Configuring the LIS

The PROCLEIX
from the instrument to middleware software or a laboratory information system. The system
administrator must configure the PROCLEIX
setup before results can be transmitted.
Note: The PROCLEIX
a Novartis Diagnostics Service Representative, not on a domain. For information about
accessing LIS files from the PROCLEIX TIGRIS System workstation over a network
connection, please contact Novartis Diagnostics Technical Service.
To configure the LIS:
1. If the LIS Configuration button is not enabled on the Configuration screen, click Stop in
the LIS Control panel. The status changes from "Idle" to "Stopped."
Note: The purpose of the Start and Stop buttons is to control the transmission of
LIS files from the PROCLEIX
status must be "Stopped" to set the export location.
2. On the Configuration tab of the Configuration screen, click LIS Configuration....
An LIS Configuration window and Export Path window open.
3. Click OK to exit the Export Path window.
4. In the LIS Configuration window, select either Export File or ASTM 1381/1394 as desired,
then configure accordingly as follows:
Export File Configuration
a) Enter one of the following export paths in the Set New Export Path field.
♦
♦
ASTM 1381/1394 Configuration
a) From the drop-down menus, select values for the following:
♦
♦
♦
♦
b) Do not check the box for Show Patient Name in Test Request as Patient ID—
Test Requests are not supported for the PROCLEIX
5. Use the check boxes at the bottom of the screen to set transmission options:
♦
Auto Transmit Results – automatically transmits bracketed worklist results as they
become available.
®
PROCLEIX TIGRIS System Operator's Manual
Volume I: Operating the Instrument
®
TIGRIS System LIS interface allows for unidirectional file transfer of results
®
TIGRIS System workstation will be set up on a local workgroup by
To save LIS data to the PROCLEIX
"C:\TIGRIS\Export."
To save LIS data to the CD-RW drive, enter "D:\."
Baud Rate
Data Bits
Parity
Stop Bits
Note: The Auto Transmit Results option is only available when the export
path is set to the hard drive.
®
TIGRIS System software according to the site
®
TIGRIS System computer to an export location. The
®
TIGRIS System computer hard drive, enter
S P
UPERVISOR ROCEDURES
®
Assays.
Part # 902649EN Rev. A
5-19