Itfrontendmode - Novatel OEM6 Integration Manual

Chapter 2 New for OEM7 – Firmware

2.2.15 ITFRONTENDMODE

Configure the front end mode settings
Platform: OEM729, OEM719, OEM7700
Use this command to configure the front end mode for each RF path to use the firmware default
or HDR (High Dynamic Range) mode. The HDR mode is used in an interference environment to
obtain best interference rejection in general. However, the power consumption will increase in
this mode.
Message ID: 2039
Abbreviated ASCII Syntax:
ITFRONTENDMODE frequency mode
Factory Default
ITFRONTENDMODE default cic3
ASCII Example:
ITFRONTENDMODE default hdr
Field Field Type
ITFRONTENDMODE
1
header
2 frequency
3 mode
Binary Value
1
OEM6 to OEM7 Integration Guide v1
ASCII Binary
Value Value
Command header.
- - See Messages for
more information.
See Table 15:
Set the frequency
Frequency Bands
band for adjustment
below
See Table 16:
Select the desired
Mode on the next
mode
page
Table 15: Frequency Bands
ASCII Value
DEFAULT Select the default frequency for adjustment
Description Format
-
Enum
Enum
Description
Binary Binary
Bytes Offset
H 0
4 H
4 H+4
40