HP 5890 SERIES II Service Manual page 274

DATA COMMUNICATIONS
COMMUNICATION INTERFACE COMPONENTS
There are five possible data communication options which may be encountered in instruments found in
the field. The five options are Non- Buffered INET, Buffered INET, RS- 232- C, HPIB/RS- 232- C
(DICE), and analog input. Communications Interface PCBs are optional and may not be installed in all
instruments.
Specific part numbers are not given in this section. For replacement part numbers, refer to the Section
9 of the IPB (Electronics).
This document is not meant to provide instruction for first time installation of any of the options dis-
cussed. The add- on sheets, which accompany the various options, exist for just this purpose, and
should be referenced when performing a first time installation.
COMMUNICATION INTERFACE COMPONENTS
Replace Communications Interface PCB
Replace Rear Panel Connector PCB and/or Cable for DICE PCB
INET CONFIGURATION
Switching Between " Global"and " Local"
INET/HP- IL Adresses
Verifying the HP 5890 Series II INET Address
Setting the Default HP- IL Address
INET- HP 5890 Signal Definition
HP- IL Loopback Test
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SVC 10- 1
Section 10
. . . . . . . SVC 10- 1
SVC 10- 2
. . . . . . SVC 10- 5
SVC 10- 8
SVC 10- 8
SVC 10- 9
SVC 10- 10
SVC 10 - 10
SVC 10- 10
SVC 10- 12