Download  Print this page

Advertisement

INET CONFIGURATION
(" CALIB AND TEST"function 3)
C O N F I G U R E
G L O B A L
L O C A L
Switching Between " Global"and " Local"
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
The CONFIGURE NETWORK function provides four features: verifying the
INET address for the HP 5890A (as determined through automatic loop
configuration), setting the default HP-IL address to be used when the
HP 5890A is connected to some device where addresses must be set
manually (i.e., no automatic loop configuration), switching the INET
function at the HP 5890A between " global"or " local,"and verifying INET
signal definitions. Each feature is discussed separately.
INET Configuration
N E T W O R K
A D D R :
A D D R :
Figure 13-4. " CONFIGURE NETWORK"Displays
Figure 13-4 shows displays resulting from the key sequence:
CLEAR
With regard to the INET function at the HP 5890A, there are two
operating modes: " global"or " local."In " global"mode (default mode),
HP 5890A
and
START
STOP
the INET loop. In " local"mode, however, pressing
the HP 5890A affects only the HP 5890A. A run may be started or stopped
at the HP 5890A without affecting other devices on the INET loop.
In " local"mode, note that the HP 5890A remains part of the INET
system; it reports its " readiness"to the system and pressing " START"and
SVC 10- 8
ACTUAL
SETPOINT
ACTUAL
SETPOINT
1 i 3 1
ACTUAL
SETPOINT
1
3 1
i
3174
.
3
ENTER
keys, when pressed, affect other devices on
START
or
at
STOP

Advertisement

Chapters

Table of Contents

   Also See for HP 5890 SERIES II

   Related Manuals for HP 5890 SERIES II

Comments to this Manuals

Symbols: 0
Latest comments: